Murakami Pink Aquasol HVP -Pure Photopolymer Emulsion Gal
Discharge and Water-based textile ink systems.
Pink colored PVA-SBQ Pure Photopolymer Direct Emulsion
Pre-sensitized for immediate use
Fast exposures, 3-5x faster than diazo based emulsions
Excellent for use with Plastisol as is, or for Discharge and Water-based ink systems when 8 grams of diazo per gallon is added and when hardened with Murakami Hardeners. (MS or A&B Hardeners)
Virtually pin hole and fish eye free
Extremely durable on press
Outstanding resolution and definition properties
42% solids content.
Handle under yellow safe lights. Avoid exposure to sunlight, flourescent and incandescent lights.
This PVA-SBQ emulsion is ready to use.There is no need to add sensitizer.
It is important to remove any contamination, residual inks, cleaning chemistry, or general dirt and dust.
Completely dry the screen before coating.
Use a clean dry coating trough that has a nick free surface for smooth coating. Apply one or two coats of emulsion to the print side. Rotate the frame 180 degrees and apply one or two coats of emulsion to the squeegee side. • Additional coats may be added to the print side if thicker stencils are required.
Dry the coated screen horizontally with the print side down in a clean light safe area. The following will help to ensure complete drying:
• 86° to 104° degrees F (30° to 40° C)
• 30% to 50% relative humidity
• Good air circulation
The use of a screen drying cabinet with heated airflow can help in maintaining these conditions.
Clean the film positives and vacuum frameglass prior to exposure to minimize pinholes.
Exposure is affected by mesh color, emulsion type, coating thickness, lamp type and the age of the bulb itself.
For best results use an exposure calculator to determine the correct exposure time.
It is important that a lamp designed for exposing screen printing emulsions is utilized.
Note: The use of film positives that are either frosted or have weak black density can reduce resolution and definition qualities of the coated screen.
86 W 55-65 Secs
110 W 50-60 Secs
200 Y 70-90 Secs
300 Y 60-80 Secs
350 Y 35-50 Secs
Note: All exposure times listed above are suggested times using a 5KW Metal Halide lamp at a distance of 40”.
Gently spray both sides of the screen with lukewarm water, wait a few seconds to allow emulsion to soften then wash print side of screen until image is fully open.
Rinse both sides thoroughly and dry. The use of a drying cabinet or fans is recommended to dry the screen.